Flying Around Arrangement

The other day I showed you most of a photo of Flying Around. After posting that, I started in on the last two Friendship Circles.

Flying Around detail
Flying Around detail

The placement of these will be tricky for a number of reasons. First, they will be on the floor (see the bottom most red Friendship star? It is right at the bottom of my design wall) as I place them unless I sew together the top and move everything up. I have been wanting to do that, but am waiting because I am not sure I am happy with the top middle of the piece. That big piece of grey at the top is of concern to me. I wonder if it pushes the Flying Geese down too much.

I want the Geese around the edge to act as a border without being a separate entity, but I am not sure that particular section achieves that goal.

Next, I don’t want the ratio of width to length to be too strange. If the piece gets to be too long, it might look too long and skinny. Of course, I am often hampered by the width of my design wall and this is the case with this piece. Sigh. I don’t want to take apart the whole piece and make it wider, so I have to measure and try and estimate how long it will be.

I also need the Flying Geese to wrap around each of the Friendship Circles and there isn’t quite enough space for them to do that with the placement of the red HSTs. You can see that dark Goose near the second Friendship Star; notice how crowded that area appears. Of course, I could move the red Friendship Circle over to the left, but I also don’t want it to be directly below the red-violet circle. I want them to appear randomly placed. The width is really a problem for me.

As you can see, there is still work to do on this piece. I started it sometime in April, I think, so it has been on the wall for a long time. I would like it to be finished, but I also want it to be right.

Author: JayeL

Quiltmaker who enjoys writing and frozen chocolate covered bananas.

Leave a Reply

Your email address will not be published. Required fields are marked *